Vimar Eikon 20461 - Page 97

ENGLISH - 39
6.8.6
Insert a SLAVE smart card, that has al-
ready been programmed by the synchro-
nising reader/programmer, into the reader
being synchronised.
The device waits for the synchronising smart
card for about 2 minutes, after which the LED
turns yellow and no further commands are ac-
cepted.
To resume normal operation, place dip-switch 1
in the OFF position.
6.8.7
The LED switches off to signal that the
smart card code has been copied, and
the reader/programmer synchronised.
6.8.9
To exit the procedure, place dip-switch 1
in the OFF position.
If dip-switch 1 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 1 in the OFF
position.
6.8.5
Remove the MASTER smart card.
The LED turns green again, waiting for a
synchronising SLAVE smart card.
6.8.8
Remove the smart card.
The LED turns green again.
Synchronising
card
Synchronising
card
MASTER
card
MASTER
card
green
green
1 2 3
4 5 6
7 8
ON
off
green
off