Send the data
Do your measurement.
Click the Data Export button followed by the Data Record button .
Note:
Depending on the setup configuration you may be required to click the Data Export
button before selecting the Data Record button.
6.11 How do I compare lenses?
Save the data
Click on Save button
The measurements can be saved both in Analyze mode and in Single Lens mode.
You can save and compare up to three lenses.
Go to analyze interface
Click on Compare button ( ).
The saved results are displayed.
6.12 How do I upgrade the software?
Download the new version to a disk-on-key.
Insert the disk on key into the USB port of the device.
Click on Tools button
Click on Technical maintenance button
Click on Software Upgrade button
The software download procedure starts.
6.13 How do I refresh the system?
Notes:
The system needs to be reset only if there are problems of measurements.
Verify that the detector is clean.
Verify that the Frame Holder is empty and is in the open state (home position).
To Next Page
Loading...
