Visonic PowerMaster-360R - Setting Zone Bypass Option

4. Programming
18 D-307083 PowerMaster-360R Installer's Guide
To change your Master Installer or Installer Codes proceed as follows:
Step 1

Step 2

Step 3

Step 4
Select 01:INSTALL
CODES Option
[1]
Select Master Installer,
Installer code or Guard
code
[2]
Enter NEW Master Installer,
Installer code or Guard code
[3]



INSTALLER MODE
NEW MASTER CODE
MASTER CODE

999
 to step 2
 to step 2
ENTER CODE:

 or
or

NEW INST. CODE
INST. CODE

888
 or
or
01:INSTALL CODES
NEW GUARD CODE
GUARD CODE

000
  to step 2

 – Setting Installer Codes
[1]
Enter the Installer Mode menu and select the 01:INSTALL CODES option (see section 4.2).
[2]
Select the NEW MASTER CODE, NEW INST. CODE or NEW GUARD CODE. Some panels may have only
the Installer Code and New Guard Code option.
[3]
Enter the new 4-digit Code at the position of the blinking cursor and then press .
Notes:
1. Code 0000 is not valid for Master Installer or installer.
2. Inserting 0000 for the Installer will delete the Installer Code.
3. Warning! Always use different codes for the Master Installer, for the Installer and for the Users.
If the Master Installer Code is identical to the Installer code, the panel will not be able to recognize the
Master Installer. In such a case, you must change the Installer code to a different code. This will re-
validate the Master Installer code.
4.3.1 Identical installer and master installer codes
In a 2-installer code system, the non-master installer may inadvertently change the Installer Code to that of the Master
Installer Code. In this case, the panel will allow the change in order to prevent the non-master installer from realizing the
discovery of the Master Installer's Code. The next time the Master Installer enters the Installer Mode, the Master Installer
will be considered an Installer and not a Master Installer. In this case, the Master Installer should use one of the following
solutions:
1. Access the panel using the Remote Programmer PC software application and change the Master Installer
Code to a different code than the one programmed by the Installer.
2. Change the Installer Code to a temporary code exit the Installer Mode as follows:
a. Enter the Installer Mode again using the Master Installer code (the Master Installer Code will now
be accepted).
b. Change the Master Installer code to a different code.
c. Change the NON-Master Installer Code back again (that is, undo the change to the temporary
code) so that the NON-Master Installer can still enter the system.
4.4 Zones and devices
4.4.1 General guidance & ZONES/DEVICES menu options
From the ZONES/DEVICES menu you can add, configure, and delete devices.
To select an option follow the instructions below. See section 4.2 for more information.
INSTALLER MODE

02:ZONES/DEVICES

MENU

indicates scroll
and select
Option
Use
Section
ADD NEW DEVICES
To enroll and configure the device's operation according to your preference and
in the case of sensors to also define their zone name (location), zone type and
chime operation.
4.4.2
DELETE DEVICES
To delete devices from the system and to reset their configuration.
4.4.3
MODIFY DEVICES
To review and/or change the device's configuration.
4.4.4
REPLACE DEVICES
To replace faulty devices with automatic configuration of the new device.
4.4.5
ADD TO SOAK TEST
To enable the Soak Test for device zones.
4.4.6
DEFINE DEFAULTS
To customize the defaults of the device's parameters according to your personal
preferences for each new device enrolled in the system.
4.4.7