Visonic PowerMaster-360R - Communication; General Guidance - Communication Flow-Chart & Menu Options

4. Programming
D-307083 PowerMaster-360R Installer's Guide 35
4.6 Communication
4.6.1 General guidance – Communication flow-chart & menu options
The COMMUNICATION menu enables you to configure and customize the communication and reporting of alarm,
troubles and other system events for monitoring companies or private users according to your local requirements and
personal preferences. PowerMaster-360R offers a variety of communication means including Cellular GSM, GPRS,
EMAIL, MMS or SMS and IP via broadband internet connection.
The 04.COMMUNICATION menu contains several sub-menu options, each covering a group of configurable features
and parameters related to the communication and reporting as follows (see detailed list in Step 3 of the chart below):
Option
Description of features and parameters
Section
2:GSM/GPRS/SMS
Contains configurable features and parameters related to the Cellular connection
of the PowerMaster-360R system.
4.6.2
3:C.S. REPORTING
Contains configurable features and parameters related to Reporting of event
messages to Monitoring Stations via cellular or IP broadband communication.
4.6.3
4:PRIVATE REPORT
Contains configurable features and parameters related to Reporting event
messages to Private Users via email, MMS or SMS.
4.6.4
5:MOTION CAMERA
Contains configurable features and parameters related to Motion Cameras for
Video Alarm Verification.
4.6.5
6:UP/DOWNLOAD
Contains configurable connection information, access permission and security
codes related to the Upload/Download procedures via GPRS.
4.6.6
7:BROADBAND
1
Contains DHCP Client settings, enables to enter LAN parameters, to reset
broadband module and to enter LAN parameters.
4.6.7
8:Wi-Fi
Contains configurable Wi-Fi connection parameters. Only in the event that a
wired connection is not available is the Wi-Fi connection used.
From V19.4 onwards PowerMaster-360-R has the ability to connect to an
internet router by Wi-Fi to communicate and report alarms, troubles, and other
system events. Wi-Fi client configuration is available through the VisonicGO
application.
To enter the 04.COMMUNICATION menu and to select and configure an option, proceed as follows:
Step 1
Step 2
Step 3
Step 4
Select COMMUNICATION
Select Communication
Sub-menu option
Select the Communication Parameter you wish to configure




See
INSTALLER MODE

04.COMMUNICATION
2:GSM/GPRS/SMS
GPRS PASSWORD
4.6.2

SMS REPORT
NETWORK ROAMING
GPRS APN
REQUEST OPERATOR
GPRS USERNAME
OP. BLACK LIST
SIM PIN CODE
NETWORK TYPE
GPRS ALWAYS ON
GSM KEEP ALIVE
TRANS. PROTOCOL
3:C.S. REPORTING
01:REPORT EVENTS 
4.6.3

02:1st RPRT CHAN
47:GSM RETRIES
() These options
are available only to
the Master Installer
05:DUAL REPORT
48:BB IP RETRIES
11:RCVR1 ACCOUNT 
51: AUTO-TST LOOP
12:RCVR2 ACCOUNT 
52:AUTO-TST TIME
21:IP RCVR 1 
53:COM.FAIL RPRT
22:IP RCVR 2 
GSM/GPRS FAIL
BROADBAND FAIL
26:SMS RCVR 1 
61:RPRT CNF ALRM
27:SMS RCVR 2 
62:RECENT CLOSE 
28 : RCVR 1 DNS
29 : RCVR 2 DNS
63:ZONE RESTORE
64:SYST.INACTIVE
66:24H ZONE RPRT
1
The name of the product is PowerLink3 IP Communicator