4. Programming
D-307083 PowerMaster-360R Installer's Guide 23
A zone for outdoor areas where an activated alarm does not indicate intrusion into the
house. This zone type generates an alarm when the system is armed both in AWAY and
HOME modes. Events are sent to private phones and not to the Monitoring Station.
This zone type behaves as an “Interior” zone when the system is armed ‘Home’ and as a
“Delayed” zone when the system is armed ‘Away’.
This is a 24 hour zone operating all of the time even when the system is disarmed. The
tamper zone reports tamper alarm events from an external wired device.
The behavior is the same as opening the tamper switch of a detector.
This is a 24 hour zone that operates all of the time even when the system is disarmed. The
line fail zone reports phone line failures from an external wired receiver that is connected
to a phone line.
This is a 24 hour zone that operates all of the time even when the system is disarmed. The
PSU fail zone reports power supply failures from an external wired device.
This is a 24 hour zone that operates all of the time even when the system is disarmed. The
panic zone reports panic events from any panic device to the monitoring station or private
telephone numbers. A panic event generates an audible siren alarm.
This zone type is active 24 hours, even when the system is disarmed. It is used to report
freezer trouble. The freezer trouble zone reports a trouble from an external (3
rd
party)
temperature device if it detects a change in temperature. Freezer trouble beeps can also
be produced by the siren if enabled. This zone type is often used with refrigerators with an
external output temperature detector. If the temperature inside the refrigerator is above a
defined value the refrigerator can trigger the output connected to the freezer trouble zone
type, and the PowerMaster panel will trigger a freezer trouble alert.
These Zone types are useful mainly when arming and disarming the system from inside the protected
premises. If you arm and disarm the system from outside without tripping any sensor, such as using a
keyfob, it is better to use the other Zone Types.
Select DELETE
DEVICES Option
Select the respective
device Group
Select exact device
you wish to delete
To delete the device:
press the key
Z01:Motion Sens
ID No. 120-1254
Enter the Installer Mode Menu, select the 02.ZONES/DEVICES option (see section 4.2) and then select the
DELETE DEVICES option.
Select the respective group of the device you wish to delete. For example, MOTION SENSORS.
Scroll the Device Group, identify (by zone and/or ID number) the exact device you wish to replace, for
example: Z01: Motion Sensor > ID No. 120-1254 and press the button.
The display prompts you <OFF> to delete. To delete the device, press the (OFF) button.
To Next Page
Loading...
