Visonic PowerMaster-360R - 7 Reading the Event Log

7. Reading the event log
D-307083 PowerMaster-360R Installer's Guide 67
7. Reading the event log
Up to 100 events are stored in the event log. You can access this log and review the events, one by one. If the event
log fills up completely, the oldest event is deleted upon registration of each new event. The date and time of occurrence
are stored for each event.
Note: Up to 1000 events are stored in the event log that can be reviewed via the Remote Programmer PC software
application or by the remote PowerManage server.
When reading the event log, events are shown in chronological order - from the newest to the oldest. Access to the
event log is provided by clicking the button and not through the Installer Mode menu. The reading and
erasing process of the event log is shown below.
Step 1

Step 2

Step 3

Step 4

In normal operating
mode
[1]
Enter Installer Code
[2]
Reviewing Events
[3]
Scroll List of Events
[4]
READY 00:00
ENTER CODE: 
Z13 alarm
SR2 TAMPER-ALARM

LIST OF EVENTS
09/02/11 3:37 P
07/02/11 11:49 a
Step 5

Step 6

Step 7

Step 8

CLEAR EVENT LOG
display
[5]
Erase the Event Log
[6]
Event Log is erased
[7]
Returns to normal
operating mode
[8]
➯

CLEAR EVENT LOG
<OFF> to delete
<OK> TO EXIT
READY 00:00

 - Reading Events
[1]
While the system is in the normal operating mode, press the key.
Reading the Event Log
[2]
Enter the current Installer Code and then press to enter LIST OF EVENTS.
[3]
The latest event is shown.
The event is displayed in two parts, for example, Z13 alarm then 09/02/10 3:37 P.
Note: In Soak Test mode, the panel displays the alarmed zone and alternates with Zxx:Soak T.Fail.
[4]
Press repeatedly to scroll through the list of events.
Erasing and Exiting the Event Log:
[5]
From anywhere within the event log, press the button and then press .
[6]
At this stage in the procedure, clicking the or buttons will take you to <OK> TO EXIT
without erasing the event log. Clicking the button will revert to CLEAR EVENT LOG.
Press the button to erase the event log.
[7]
The system erases the event log
[8]
Press to revert to normal operating mode.
Clicking the button repeatedly at any stage in the procedure takes you one level up with each click.
Clicking the button will take you to <OK> TO EXIT.