4. Programming
54 D-307083 PowerMaster-360R Installer's Guide
4.11 Factory default
The FACTORY DEFLT menu enables you to reset the PowerMaster-360R parameters to the factory default
parameters. To obtain the relevant parameters defaults, contact the PowerMaster-360R dealer. Reset factory default
parameters as follows:
Select 09:FACTORY DEFLT
menu
Resetting of factory default
parameters is underway
Notes:
1) For PowerMaster-360R with 2 installer codes, INSTALLER code and MASTER INSTALLER code, only the master
installer code enables to perform the factory default function.
2) If the Soak Test is active, performing factory default will restart the Soak Test.
4.12 Serial number
The SERIAL NUMBER menu enables reading the system serial number and similar data for support purposes only. To
read the system serial number and other relevant data proceed as follows:
Select 10:SERIAL
NUMBER menu
Click next repeatedly to view
relevant data.
Control panel serial number
Control panel software
version
Control panel ID for
PowerManage connectivity
Control panel default version
Control panel boot version
Control panel Remote
Software Upgrade
downloader version
Displays the PowerLink
software version
Displays the cellular modem
type, if installed.
4.13 Partitioning
4.13.1 General guidance – Partitioning menu
This menu allows you to enable/disable partitions in the system (for further details, see APPENDIX E).
4.13.2 Enabling and disabling partitions
To enable or disable the partition feature, proceed as follows:
Select 12:PARTITIONING menu
Select whether to Enable or Disable
Partitions
Partitions are
now enabled
To Next Page
Loading...
