Visonic PowerMaster-360R - 8. Maintenance; Replacing Backup Battery; Replacing Wireless Devices Batteries; Event Log

4. Programming
D-307083 PowerMaster-360R Installer's Guide 51
Option
Instructions
The following screens will appear: Xxx: 24hr: <status>
1
 Xxx: NOW: <status>
1
Use to scroll between the device's families.
To view additional information of the selected device, press . The following screens will
appear: Xxx <device name>
1
 <location>
1
.
If the control panel receives information via a repeater, it will be displayed as follows:
Xxx <device name>
1
 <location>
1
 RPx:Via Repeater
SHOW RF PROBLEMS
You can view only the devices which have RF problems.
Note: This option is available only after testing process was done.
Press to view the devices' status.
The following screens will appear: Xxx: 24hr: <status>
1
 Xxx: NOW: <status>
1
Use to scroll between the device's families.
To view additional information of the selected device, press . The following screens will
appear: Xxx <device name>
1
 <location>
1
.
If the control panel receives information via a repeater, it will be displayed as follows:
Xxx <device name>
1
 <location>
1
 RPx:Via Repeater
<OK> TO END
Select to terminate the diagnostics test.
4.9.3 Testing the GSM module
The PowerMaster-360R enables to test the panel’s integrated GSM module.
07:DIAGNOSTICS
  
GSM/GPRS Please wait…
Enter the GSM/GPRS menu, and press to initiate the GSM diagnostic test. Upon test completion, the
PowerMaster-360R will present the test result.
The following table presents the test result messages.
Message
Description
Unit is OK
GSM / GPRS is functioning correctly
GSM comm. loss
GSM/GPRS module does not communicate with the Panel
Pin code fail
Missing or wrong PIN code. (Only if SIM card PIN code is enabled.)
GSM net. fail
Unit failed with registration to local GSM network.
SIM card fail
SIM not installed or SIM card failure.
GSM not detected
GSM auto enroll failed to detect GSM/GPRS module.
No GPRS service
The SIM card does not have the GPRS service enabled.
GPRS conn. fail
Local GPRS network is not available or, wrong setting to GPRS APN, user and/or password.
Srvr unavailable
PowerManage receiver cannot be reached – Check the Server IP
IP not defined
Server IP #1 and #2 are not configured.
APN not defined
APN is not configured.
SIM card locked
After entering a wrong PIN code 3 consecutive times the SIM is locked. To unlock it enter a
PUK number. The PUK number cannot be entered by the control panel.
Denied by server
PowerManage denies the connection request. Check that the panel is registered to
PowerManage.
4.9.4 Testing the SIM number
You can test the SIM number to ensure that the SIM number was entered correctly in the control panel (see section
4.6.2) and to coordinate with the operator.
07:DIAGNOSTICS
  
SIM NUMBER TEST
  
Enter the SIM NUMBER TEST menu, select the IP server (out of two) used for the verification of the SIM and press
. The server sends a test SMS to the panel.