Visonic PowerMaster-360R - Appendices; Appendix A. Controlling Device Functions

4. Programming
D-307083 PowerMaster-360R Installer's Guide 53
4.9.6 Testing the WLAN Module
The WLAN diagnostic procedure enables a test of the communication of the WLAN Module with the PowerManage server
and reports the diagnostic result. In case of communication failure, detailed information of the failure is reported.
07:DIAGNOSTICS
  
08: WLAN
  
PLEASE WAIT… Unit is OK
The following table presents the list of messages that might be reported:
Message
Description
“Please wait…”
Test in progress
0 – “Success”
WLAN is ok
1 – "Wi-Fi disabled”
Wi-Fi client is not enabled
2 – “Router disconn.”
No connection to router (no link, or wrong SSID or password)
3 – “DHCP failure”
Plink fail to gel IP from DHCP server (router)
4 – “Wrong password”
Wrong SSID or password
5 – “No WAN”
Plink fail to connect DNS or 8.8.8.8
6 – “Wi-Fi is OK”, status of
both servers.
“RCV1: OK RCV2: OK”
“RCV1: OK RCV2: --”
“RCV1: OK RCV2: ER”
“ER” – No connection to server
“--“ – Empty IP Unreachable
7 –“Plink general err”
General Plink error
8 – “No Wi-Fi module”
No Wi-Fi module detected
9 – “Eth. connected”
Ethernet connection detected
4.10 User settings
This USER SETTINGS menu provides you with a gateway to the user settings through the regular user menus.
Refer to the PowerMaster-360R User's Guide for detailed procedures.