APPENDIX I. Compliance with standards
82 D-307083 PowerMaster-360R Installer's Guide
APPENDIX I. Compliance with standards
Compliance with standards
European Standards: EN 300220, EN 300328, EN 301489, EN 50130-4, EN 60950-1, EN
50130-5, EN 50131-3, EN 50131-4, EN 50131-6, EN 50136-1,2, EN 50131-10
According to the European standard EN50131-1 and EN 50131-3, the PowerMaster 360R
security grading is 2 - "low to medium risk" and environmental classification is II – "indoor
general". The power supply type is A according to EN 50131-6, built-in siren -type Z warning
device according to EN50131-4, and ATS Category is DP4, when IP module primary path and
GPRS secondary, according to EN50136-1, EN50136-2 (pass through Operation Mode) and
according to EN 50131-10 – Supervised Premises Transceiver (SPT).
Certified by Applica T&C in accordance with
EN 50131-1, EN 50131-3, EN 50131-4, EN 50131-6,EN 50131-5-3, EN 50130-5,
EN 50130-4, EN 50131-10, EN 50136-1, EN 50136-2
Applica T&C has certified only the 868MHz variant of this product.
UK: The PowerMaster-360R is suitable for use in systems installed to conform to PD6662:2010
at Grade 2 and environmental CLASS II. DD243 and BS8243
Hereby, Visonic Ltd. declares that the radio equipment type PM-360R is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.visonic.com/download-center.
U.S Standards: (FCC) CFR 47 part 15
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance (Visonic Ltd.) could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING! To comply with FCC RF exposure compliance requirements, the device should be located at a
distance of at least 20 cm from all persons during normal operation. The antennas used for this product must not
be co-located or operated in conjunction with any other antenna or transmitter.
To Next Page
Loading...
