Visonic PowerMaster-360R - Configuring Upload; Download Remote Programming Access Permissions

4. Programming
D-307083 PowerMaster-360R Installer's Guide 43
4.6.6 Configuring upload / download remote programming access permissions
Using a PC, the PowerMaster-360R can be configured (by upload/download) either locally or from remote via GPRS
cellular communication.
Local programming can be performed by directly connecting the computer to the panel's USB port using the Remote
Programmer PC Software.
Remote programming via GPRS is performed using a Visonic PowerManage server and related Remote Programmer
PC software. The PowerManage server calls from a cellular modem to the Panel's SIM card number. The panel checks
the caller ID and if identical with any of the two callers ID 1 or 2 programmed in the GPRS UP/DOWNLOAD menu (see
table below), the panel initiates a GPRS connection with the respective IP Receiver 1 or 2 (as configured in section
4.6.3 options 21 & 22). When connection is established, the monitoring company can perform the upload/download
procedure via the established secured GPRS connection. For further information refer to the PowerManage User's
Guide.
In this section you can configure the access permissions (i.e. security codes and identification) and determine the
functionality of the upload/download procedures via GPRS channel.
04:COMMUNICATION
  
6:UP/DOWNLOAD
  
MENU item
Enter 6:UP/DOWNLOAD, select the menu to configure (see guidance above and in section 4.6.1), then refer to the
table below for configuration instructions.
Option
Configuration instructions
UP/DWNLOAD PARAM
Configure the Upload/Download functionality. The functionality is determined through a
sub-menu of the UP/DOWNLOAD option as shown below.
To program:
Press to enter the UP/DOWNLOAD sub menu and then select and configure each of
the sub-menu options as shown below. When done, press to return.

Remote access
Enable or disable the remote access to the system. If disabled, the system cannot be
accessed remotely thereby inhibiting the Upload/Download and the Remote Control via
GSM analog communication channel (see Chapter 5 in the User's Guide).
Options: enabled (default); disabled.
Mast. UL/DL code
Enter the 4-digit password (Master Installer download code) code that will allow the
Master Installer to access the system remotely and upload/download data to the
PowerMaster-360R panel.
Note: 0000 is not a valid code and must not be used.
Inst. UL/DL code
Enter the 4-digit password (Installer download code) code that will allow the Installer to
access the system from remote and upload or download data into the PowerMaster-360R
panel.
Notes:
1. 0000 is not a valid code and must not be used.
2. The installer can configure via UL/DL only the options he is authorized to configure from
the control panel.
UL/DL modes
Define whether the downloading/uploading can be performed in Disarm mode (state) only
or in all modes (i.e. Away, Home & Disarm).
Options: in all modes (default) or in DISARM only.
(Return)
GPRS UP/DOWNLOAD
Configure the Upload/Download functionality via GPRS. The functionality is determined
through a sub-menu of the GPRS UP/DOWNLOAD option as shown below.
To program:
Press to enter the GPRS UP/DOWNLOAD sub menu and then select and configure
each of the sub-menu options as shown below. When done, press to return.
 Panel SIM Tel.#
(Previously known as
My SIM Tel.#)
Enter the PowerMaster-360R SIM card telephone number. The PowerManage server at
the Monitoring Station sends an SMS or voice message to this number for the panel to call
back the PowerManage server via GPRS for initiating the uploading / downloading
process.