Visonic PowerMaster-360R - Page 37

4. Programming
D-307083 PowerMaster-360R Installer's Guide 37
GPRS APN
Enter the name of the APN Access Point used for the internet settings for the GPRS
(up to 40 digits string).
Note: To enter the APN Access Point, use the String Editor in section 4.9.1.
GPRS USERNAME
Enter the Username of the APN used for GPRS communications (up to 30 digits
string).
Note: To enter the Username, use the String Editor in section 4.9.1.
SIM PIN CODE
Enter the PIN code of the SIM card installed in the GSM module (up to 8 numerical
digits).
Note: To enter the numerical PIN code, use the numerical keyboard.
GPRS PASSWORD
Enter the Password of the APN used for GPRS communications (up to 16 digits
string).
Note: To enter the Password, use the String Editor in section 4.9.1.
NETWORK ROAMING
A new cellular roaming algorithm to support cases where the panel is successfully
connected to a network but GPRS connection has timed-out.
With the new roaming algorithm, in such cases the panel attempts to connect to a
different network.
Modem roam en: when selected, the panel uses the internal Cellular modem's
algorithm for roaming. (en) = enable
Roam disable: when selected, roaming is not allowed. Only the ‘Home’ network can be
accepted.
Manual roam en : when selected, the panel uses its own algorithm to select the best
cellular operator.(en) = enable
Lock network: when selected, the panel uses the operator defined in ‘Requested
Network’. (en) = enable
REQUEST OPERATOR
Specifies a preferred network for example Vodafone that the panel attempts to register
with. The signal strength must be above the Minimum RSSI value. Where a Requested
Operator is specified, the panel attempts to return to this network on subsequent
attempts.
Note: Contains an editable line to enter up to 6 numbers MCC (Mobile country code)
+MNC (Mobile network code)
OP. BLACK LIST
Used to avoid certain networks, for example, when a high signal strength operator is
unreliable or the device oscillates between networks (country borders).
Note: Contains an editable line to enter up to 6 numbers MCC (Mobile country code)
+MNC (Mobile network code).
NETWORK TYPE
Define whether to use a 2G or 3G network or whether to enable the panel to use a 3G
network as first priority or a 2G network as second priority.
Options: automatic (default); 3G; 2G.
GPRS ALWAYS ON
Define whether the control panel will stay continuously connected enabled, via GPRS
communication, or disconnect disabled (default), after each report session.
GSM KEEP ALIVE
Some GSM Service providers tend to disconnect the GSM connection if the user has
not initiated any outgoing telephone calls during the last 28 days. To prevent from
disconnecting the GSM connection, you can configure the system to generate a keep
alive GSM call every 28 days sending a test message either to the first SMS number
(if exists) or alternatively first private telephone number.
Options: Disable (default) or Every 28 days.
TRANS. PROTOCOL
Select the IP protocol used to transfer data over the internet/GPRS.
Options: TCP (default); or UDP.