50 Keyset Mode
Keyset Mode
This feature allows you to determine the mode and baud rate of the
optional CTI Module connected to your phone. This setting is
stored in back-up memory in the case of a power outage or system
reset. When telephone is set to AT command mode, these AT
commands are supported.
Mode Description
Inactive No CTI information is sent/received by the telephone.
ATD Modem Dialing Command -- The telephone will recognize
the ATD and accept digits after the command.
ATH or
ATHX
(X= 0 or 1)
Modem On-Hook/Off-Hook Command -- ATH or ATH0 will
force the telephone to go to the on-hook state from its
current state. ATH1 will force the telephone to go to the off-
hook state from it’s current state.
CKTU Command used with Wanderer (a cordless key telephone
unit). The baud rate is not used in this mode; no change is
necessary.
PC Phone CTI information used with Discovery Desktop and Discovery
PCPhone software must be set to 4800 baud rate.
SPI Service Provider Interface -- Command used with TAPI
applications such as Discovery Link
To Next Page
Loading...
