74 Speed Dial
3. Press the ON/OFF button to end the call.
Speed Dial
A keyset user can associate up to 20 frequently dialed numbers as
Station Speed Numbers (9000-9019). Telephone numbers can be up
to 24 digits including pauses, flash commands, pulse-to-tone
switchover, and non-display characters. A pause is automatically
inserted after a flash.
To use speed dial:
1. If an outside line was not specified in programming, one can
be selected now or the system will assign the line.
2. Press SPEED and dial the speed bin location,
-or-
Press the preprogrammed speed bin button,
-or-
Use the Soft Key’s SPD option and then dial a speed bin
location when in an idle condition.
To store speed dial numbers:
1. Press SPEED.
2. Press an OUTSIDE LINE button or the POOL button.
-or-
Select an outside line by pressing the SPEED button again.
3. Dial the speed bin location.
4. Dial the telephone number and include these special codes:
TRANS Initiates a Pulse-To-Tone switchover
When used as the first entry in the speed bin, this
inserts a non-display character causing numbers
stored in the bin not to appear on the digital
telephone’s display when bin is accessed.
HOLD Inserts a Pause
FLASH Inserts a Flash into the speed number
To Next Page
Loading...
