58 Off-Hook Voice Over (OHVO)
To place an Off-hook Voice Over call:
When an OHVO station calls a busy OHVO station and a busy tone
is received, the calling OHVO station must:
Press preprogrammed OHVO button [628] or use Soft Key
OHVO to initiate OHVO announcement, the following occurs:
The HOLD button LED flashes at called OHVO station.
The OHVO receiving station receives a one-beep
warning tone. The station receiving the OHVO call must
be off-hook and in H or P mode, then the calling OHVO
party may begin the voice announcement to the called
OHVO party. The called OHVO station’s existing
conversation is uninterrupted and the voice over
announcement does not drown out the existing
conversation. If the receiving station is call forwarded,
use [5#] to override forwarding.
The calling OHVO station is not connected or able to
hear the called station’s conversation (connection only
allows calling station to transmit to the called station).
To respond to an Off-hook Voice Over:
After receiving an OHVO announcement, three options are
available to respond to the caller:
Option 1 -- allows the receiving station to respond to an OHVO
announcement using the MUTE feature button. This button is
pressed to carry on a two-way conversation with the OHVO
initiator while still listening to the original call.
The calling station is placed in a one-time DND
mode upon initiating the Voice Over. One-Time
DND cannot be toggled during the OHVO call.
The station receiving the OHVO call must be
off-hook and in H mode.
To Next Page
Loading...
