64
Timing cover and drive
17
Slide the (A8) into the keygroove to a depth of 5 mm
measured from the pulley front end plate.
NOTE! It is important that all excess Loctite is
wiped off from the front end of the crankshaft and
from the pulley before the pulley is installed.
18
Install the damper pulley (A5) on the pulley using
the four mounting screws (A6). Finger tighten the
mounting screws.
19
Install the center screw (A7) and tighten to 180 Nm.
20
Tighten the four mounting screws to:
Flanged screw 22 Nm
Domed screws 36 Nm
NOTE! Loctite 648 starts to cure after seven min-
utes at 22° C. It is important to tighten the these
mounting screws within the given time limit.
21
Install the timing belt, operation 15A-04. Remove
the fixing pin for the fuel injection pump pulley and
adjust the belt tension, operation 15A-03.
22
Check the fuel injection pump adjustment, opera-
tions 17A-03.
23
Carefully turn the crankshaft two revolutions to en-
sure that there is nothing preventing free move-
ment.
24
Install the cap of the timing cover, operation 15A-01
and install the inspection hatch.
25
Install the screw in the adjustment hole in the cam-
shaft cover.
26
Install the starter motor, operation 23B-01.
27
Connect the battery.
To Next Page
Loading...
