Service and maintenance
Lubrication and service chart 161
*) For conditions for the interval of 500 hours to apply, see page 109.
**) Or when changing the engine's oil filter. If the filter becomes clogged earlier, it must be replaced.
Measure Page
Item
DAILY (every 10 hours)
Check the brake function 143 1
Check function of control lamps, operating controls, travel and working
lights, and that there are no leaks.
2
Measure Page
Item
EVERY 50 HOURS
After carrying out Daily service
Check draining of compressed air tanks 145 3
Check the brake fluid level, 5 reservoirs 143 4
WARRANTY INSPECTION shall be performed at the first 100 hours according to the Service Programme
Measure Page
Item
EVERY 250 HOURS
After carrying out Daily and 50 hour services
Check dropbox 139 5
Check drive axles 141 6
Change oil, oil bath air cleaner (optional equipment) 120
Grease steering joints and steering cylinders 15
Grease tipping cylinder bearing 7
Grease tipping joint bearings 8
Grease overhung tailgate (optional equipment)
Measure Page
Item
EVERY 500 HOURS
After carrying out Daily, 50 and 250 hour services
Check anti-freeze, coolant 124
Check electrolyte level, batteries 128 9
Check brake pads, service brake 144 10
Check air pressure and wear, tyres 147 10
Change oil and oil filters, engine* 109 11
Change fuel filter** 113 12
Change filter, water trap** 113 13
Grease propeller shaft, dropbox – front axle 14
Clean radiator 124
Clean condenser 152
To Next Page
Loading...
