Other controls
48 Controls
5 Longitudinal differential lock and 6x6 drive
Upper end of switch pressed in = longitudinal differential lock
disengaged
Lower end of switch pressed in = longitudinal differential lock
engaged
NOTE! Switch missing if machine is equipped with ATC.
6 Transverse differential lock, front axle
Upper end of switch pressed in = transverse differential lock
disengaged
Lower end of switch pressed in = transverse differential lock
engaged
NOTE! Switch missing if machine is equipped with ATC.
7-8 Unassigned
9 Wiper and washer, rear window
(optional equipment)
10 Unassigned
11 Load and dump brake
Press the button to apply the wheel brakes when loading and
unloading. This is to save having to use the parking brake
unnecessarily.
At the application of the load and dump brake, the transmission is
automatically shifted to neutral.
For application and release of the load and dump brake to take
place, a number of conditions have to be met, see page 70.
12 Tipping control
The tipping control has four positions:
NOTE! During loading and operating, the lever must be in
floating position (2).
NOTE! If the operator leaves the operator's seat or the start
key is turned to position 0, the tipping control automatically
moves to holding position.
See also page 77.
13 Lock-out control, tipping lever
The purpose of lock-out control is to lock the tipping control in
holding position.
Position 1 Lowering with hydraulic pressure. This position
has a spring return action – must be kept in
position by hand
Position 2 Floating position, the dump body rests on the
trailer unit frame
Position 3 Holding position, the dump body is kept stationary
in the current position
Position 4 Tipping position
A9002000
A9002100
1046071
A
1
1
1
12
11
To Next Page
Loading...
