WAGNER SPRINT 2 - Setting the Fluidization of Sprint 2 H (60 L Tank)

Operating manual Manual system SPRINT 2
7 Operation
38 Order number 2467031 | Edition 04/2024
7.2.3 Setting the fluidization of Sprint 2 H (60 L tank)
WARNING
Dust formation!
Risk of poisoning if inhaled.
Danger due to escaping dust, contamination of the device and device components.
4 The powder tank may only be filled to the halfway mark, because fluidizing increases
the volume of powder.
P_05972
1
2
1. Open the powder tank1 and fill it only halfway with powder.
2. Switch on the control unit.
3. Set the [Vibrator motor controller] parameter, on the control unit, to [ON] to
permanently activate the fluid air (see the WACON Sprint 2 control unit operating
manual).
4. Actuate the trigger lever of the gun for a short time and release it.
5. Adjust the fluid air at the throttle2 until fluidization is recognizable.
NOTICE!The amount of fluid air depends on the characteristics of the powder.
Avoid a build up of
powder dust (too much fluid air) in the powder tank!
6. Close the powder tank 1 and check whether the exhaust air hose is leading in the
direction of the exhaust system of the powder coating booth.