Wang 200 Series - Page 59

2 . 4 Troubleshooting
802.3 INTERFACE
2.4.3 Running 3C505.EXE Program (Sheet 3 of 3)
Running tests 5 and 7
1 . Remove loop back plug from inter- 3.
face board and connect PC to net-
work.
NOTE
This test is run simultaneously on two
PCs on the network, one being the
tested unit and the other serving as
an echo server. The test PC must
have a 3C505 board installed.
2. If echo server is either an Ether-
Series network s1.Jrver or another
PC having an Etherlink 3C505
card serving as echo server, insert
3C505.EXE diagnostic diskette in
server and start program running.
At DOS prompt type:
A 3C505 -7
Next, start 3C505.EXE program
running on tested PC and at DOS
prompt type:
3C505 -5 -E
NOTE
The parameters -Ix -Ox -Bxxx must be
typed in if the settings on the 3C505
board have been changed.
If echo server is another PC with
another type of 3Com Etherlink
acting as echo server, use diagnos-
tic program supplied with specific
Etherlink such as 3C501 . Start
echo server running on this pro-
gram and at DOS prompt type
A 3C501 -7
Next, start 3C505.EXE program
running on tested PC and at DOS
prompt type:
3C505 -5
e END
741-1859
Page 2-13 COMPANY CONFIDENTIAL