Wang 200 Series - Diagnostic Utility

4. 5 Troubleshooting
MICROCONTROL
4.5.4 Diagnostic Utility
NOTE
Diagnostic Utility software must be Refer to the associated PC manual for
revision 2860 or greater to run Diag- Diagnostic Utility operation proce-
nostic Utility on PC 200/300 Series dures.
Computers with the MicroControl
board installed. If the Diagnostic Util-
ity software revision is less than
2860. the Micro Control board must
be removed from the system before
Diagnostic Utility can be run. Refer to
section 4.6.1 for MicroControl board
removal.
Diagnostic Utility is a diskette based
troubleshooting aid that allows the
user or CE to run extensive diagnostic
testi11g. Diagnostic Utility part number
1 95-5537 -9 Revision 2680 or higher
supports the MicroControl option. To
run Diagnostic Utility with MicroCon-
trol installed requires MicroControl-
file 'PREPDIAG.COM' be loaded onto
the Diagnostic Utility diskette.
Perform the following to copy this file:
• From DOS Command Processor,
copy file 'PREPDIAG.COM' from the
MicroControl Security Control Menu
diskette to the Wang PC 200/300
Diagnostic Utility diskette.
741-1859 Page 4-9
e END
COMPANY CONFIDENTIAL