4-26 Maintaining and Troubleshooting the Waters 515 Pump
4. Reconnect the inlet tubing to the inlet manifold.
5. Reconnect the outlet tubing to the new draw-off valve.
6. Reposition the eluent reservoir, then prime the pump (see “Priming the
pump” on page 3-15). Check for leaks.
Troubleshooting
This section describes:
• Troubleshooting pump problems based on error messages and
malfunctions
• Identifying and correcting noises
• Identifying pump-related chromatographic problems
Contacting Waters technical service
If you encounter problems troubleshooting the 515 Pump that you cannot
resolve, contact Waters Technical Service at 800 252-4752, Canadian and
U.S. customers only. Other customers, call your local Waters subsidiary or call
Waters corporate headquarters for assistance in Milford, Massachusetts
(U.S.A.).
Warning: To prevent injury, always observe good laboratory practices
when you troubleshoot the 515 HPLC Pump.
To Next Page
Loading...
