Waters ACQUITY UPLC I-Class IVD - Preparing the System; Preparing System Hardware

Preparing system hardware
July 7, 2014, 715003736IVD Rev. C 29
3 Preparing the System
Preparing system hardware
Powering-on the system
Powering-on the system entails starting the ACQUITY UPLC I-Class IVD
system workstation, system modules, and MassLynx software. Each device or
instrument beeps three times and runs a series of startup tests. See “Status
LEDs” on page 30 and “Power LED” on page 30, for information on how to
interpret indicator LED modes for device or instrument flow status and
whether the units are powered-on.
Tip: The column heater is automatically powered-on when you power-on the
sample manager.
For mass spectrometer power-on instructions, refer to the Xevo TQ-S IVD
Mass Spectrometry System Operator’s Overview and Maintenance Guide.
Contents:
Topic Page
Preparing system hardware ............................................................ 29
Configuring MassLynx software ..................................................... 33
ACQUITY control panels................................................................. 33
Starting the ACQUITY UPLC Console........................................... 38