Watlow F4P Series

5.2 ■ Factory Page Watlow Series F4P
Enter a Password
If you try to set password security before any password
has been established, a pop-up message will give you the
opportunity to enter one. Use the . , , , > and < keys
to enter a four-character password, which can consist of
letters, numbers or both. After entering and confirming
the password, re-enter the chosen menu or page and
select Password Security. Record your password and keep
it secure.
Confirm Password:
_ _ _ _
▲▼ Adjusts Char
< Back >Next
Enter New Password:
_ _ _ _
▲▼ Adjusts Char
< Back >Next
Must reset lock
after setting the
password
■ ■ ■ Press any key!■ ■ ■
>
No Password!
Set Password?
▼ No ▲ Yes
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Use a Password
To enter a password-protected area, users must enter the
password. If an incorrect password is entered, a pop-up
message will tell you it is invalid and you may try again.
When the password is correct, choose again to enter the
menu or page of your choice.
Change a Password
The Change Password parameter is near the end of the
list under Set Lockout on the Factory Page. To change a
password, you must first enter the old password for
confirmation.
Enter Password:
_ _ _ _
▲▼ Adjusts Char
< Back >Next
.
…Factory>Set Lock___
Setup ▲
Factory ■
>Change password ▼
Invalid, Re-Enter:____
▲▼ Adjusts Char
< Back >Next