Watlow F4P Series User Manual

1.2 ■ Introduction Watlow Series F4P
Setup Steps
The
ˆˆ
Key
During all these steps, the Information Key will summon
helpful definitions and setup tips. Just position the cur-
sor next to the item you want to know more about, then
press the key. Press it again to return to your task.
See Chapter 3, Operations Page.
4
Establish a set point for static set point
control.
See Chapter 3, Operations Page.
3
Tune the system and set alarm set points.
Learn to navigate the software in Chapter 2,
Operating from the Front Panel, and then go to
Chapter 4, Setup Page. For background, you may
also want to refer to Chapter 7, Features. (This
step may not be necessary if the Series F4P is
already installed in the equipment.)
2
Configure the controller to suit your
application.
See Chapter 8, Installation and Wiring. (This
step will not be necessary if the Series F4P is
already installed in equipment.)
1
Install and wire the controller.
How to do itWhat to do
Your Series F4P may arrive as an independent unit or
already installed in other equipment. The steps below
may or may not apply to all units. The Series F4P soft-
ware can be locked with different types of security. See
Chapter 5, Factory Page.

Watlow F4P Series Specifications

General

Brand	Watlow
Model	F4P Series
Category	Controller
Language	English