7
Installation
Failure to follow all installation requirements risks possible death, personal injury,
property damage, and failure of the IntelliStation
®
to perform as intended.
• Installation of IntelliStation
®
MUST be performed by qualified technicians, including licensed electricians
and plumbers, following all manufacturer’s instructions, complying with all local, state, federal and other
governmental requirements, and with all building and construction codes and standards.
• Use ONLY with a potable water distribution system free of debris, foreign materials, corrosive chemicals
or substances, and other adverse conditions.
• IntelliStation
®
is recommended for use as part of an ASSE compliant water distribution system,
including mixing valves and/or temperature limiting devices at all point-of-use fixtures (faucets, sinks,
tubs, showers, etc.).
• IntelliStation
®
MUST be installed indoor in a dry enclosed area not susceptible to the weather elements
such as rain, snow, ice, freezing temperature, direct sunlight or excessive heat.
• Keep work area clean, well-lighted, free of clutter and distractions, and accessible only by authorized
personnel and workers.
• IntelliStation
®
Control Module and touchscreen display must be located in accessible and well-lighted
area for use, servicing, repair or replacement by authorized personnel.
• IntelliStation
®
Control Module is electrically powered. ALWAYS take proper precautions to recognize,
evaluate, and control electricity hazards during installation, programming, use and service/maintenance.
WARNING
!
NOTICE
Installation of IntelliStation
®
is performed by the owner using qualified and licensed trades such as
plumbers and electricians, following all local, state, federal and other governmental requirements, and all
building and construction codes and standards. Step-by-step installation instructions depend upon the
application and the configuration of the building’s water distribution system.
All installations require thorough flushing of all piping BEFORE installation, and testing for and eliminating all
leaks before and after installation.
Check valves are recommended to prevent cross-flow.
To Next Page
Loading...
Need help?
General
