12
To set and enter a passcode and unlock the system, follow instructions in the “Set Up and Programming”
section of this Manual.
The Set up Function allows the user to access three menus:
■ “System”
■ “Network”
■ “BAS”
The icon on the Unlock function screen is deactivated until the user enters the correct passcode.
The icon will take you back to the Programming Menu.
The icon will show additional information if available.
After entering the correct passcode, the “Setup”, “Monitor”, “Sanitize” and “Toolbox” functions can be
accessed from the “Programming” Menu screen.
The following Sections generally outline and describe these functions.
Touching the icon on the “Programming” Menu will allow access to the Setup function:
Setup Function
Description of Controls and Functions
NOTICE
System Network BAS
Setup
Back
?
To Next Page
Loading...
Need help?
General
