EasyManua.ls Logo

Wavetek TETRA MS Test - Table of Contents

Default Icon
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
"
For differences from former software versions: see the Timeline at the end of this supplement.
Contents
Introduction
............................................................................................... 10-5
What TETRA stands for................................................................................ 10-5
What is tested EVERYWHERE? .................................................................. 10-6
Measurements possible with TETRA – an overview .................................... 10-6
General Preparations
............................................................................. 10-7
Hardware and firmware compatibility ........................................................... 10-7
Loading system software............................................................................. 10-8
Test Setup (Connectors)............................................................................... 10-9
Parameters
.............................................................................................. 10-10
Basic parameters on basic mask................................................................ 10-10
Basic parameters in DEF.SET.................................................................... 10-12
SYSINFO parameters in DEF.SET............................................................. 10-17
Modes of operation
............................................................................... 10-19
MEASURE: Asynchronous transmitter measurements.............................. 10-19
Measurements on a mobile station....................................................... 10-19
Measurements on a base station.......................................................... 10-20
T1: The T1 generator.................................................................................. 10-21
REGISTER: Setting up a call...................................................................... 10-22
Registration (Location Update procedure)............................................ 10-23
Call from mobile station ........................................................................ 10-24
Call from base station ........................................................................... 10-25
Paging sensitivity search function......................................................... 10-26
Call cleardown....................................................................................... 10-27
TRACE: Protocol display ............................................................................ 10-28
Measurements
........................................................................................ 10-30
Measurements under remote control ......................................................... 10-30
Quality measurements from the basic mask .............................................. 10-31
Power versus time ...................................................................................... 10-33
Constellation display................................................................................... 10-35
Available display modes ....................................................................... 10-36
Modulation spectrum .................................................................................. 10-37
Statistical evaluation (Min-Max).................................................................. 10-38
AF (speech) loopback................................................................................. 10-40
AF signal generator and voltmeter access ................................................. 10-41
Troubleshooting
.................................................................................... 10-42
RS-232-C interface
................................................................................ 10-43
Application Notes ........................................................................................ 10-43
Requirements for operation .................................................................. 10-43
Control commands and transmission protocol ..................................... 10-43
Pinning of RS-232-C interface.................................................................... 10-44
10
TETRA MS Test
10-3

Related product manuals