Wavetek TETRA MS Test - Storing a Setup in an Existing File; Recalling a Setup

Storing a setup in an existing file
1) Within the system option (TETRA MS Test), set the parameters as you want
to store them.
2) Insert the memory card for your user data.
3) Call up the MEMORY mask with
{MEMORY}
.
4) Move the cursor bar to an existing TETRA-MS.SYD file from the file list.
5) Press
{STORE}
. A sub-directory with setups appears.
6) Select a vacant or an occupied setup and press
{ENTER}
. If you selected an
occupied setup, the STABILOCK will ask you whether to "OVERWRITE ???"
the existing file. Confirm with
{YES}
if you want to do so; the old setup on the
memory card is now overwritten by system parameters from the TETRA MS
Test screens.
7) If you selected a vacant setup, enter a filename as described above ("Storing
a setup in a new file"). Confirm with
{ENTER}
to store the parameters in the new
setup location.
Recalling a setup
1) Make sure the system option software (TETRA MS Test) is loaded to the
STABILOCK.
2) Insert the memory card with your system data setup file.
3) Press MEMORY to see the directory of the memory card.
4) Move the cursor bar to the file from which to load the setup parameters.
5) Press
{RECALL}
; the sub-directory is then displayed.
6) Select one of the files using the cursor keys, and press
{RECALL}
once again.
7) Press
{AUX}
,
{DATA}
to enter the system option software. The TETRA basic
mask appears, with the parameters loaded from the memory card.
TETRA MS Test Appendix
10-50