Webdyn WebdynSunPM - 3 Safety Instructions

7
USER GUIDE – WebdynSunPM
WebdynSunPM – User guide — Version 1.0
3 Safety instructions
Please follow all safety instructions in this guide.
Failure to comply with these instructions may result in damage to the devices and may be dangerous.
Electrical connection
 All wiring work must be carried out by a qualified specialist electrician.
 Before installation, all devices connected to the associated communication bus must
be disconnected on both sides (DC and AC).
 Please observe all safety instructions in the device notices.
The WebdynSunPM product can be damaged by electrostatic discharges (ESD).
Avoid contact with component connections and connector contacts.
This device is not suitable for use in places where children might be present.
Class 3 device: the device operates at extra-low safety voltage (SELV) (50V maximum).
Voltage reduction must be carried out using a safety transformer, providing safe galvanic
isolation between the primary and the secondary.
Do not install the product any higher than 2 meters.
When cleaning the product, use only a slightly damp cloth to gently clean and wipe the
surfaces.
Do not let any liquids enter, especially through the slots of the SIM card and the SD card.