Webdyn WebdynSunPM - Factory Reset; Embedded Web Interface

33
USER GUIDE – WebdynSunPM
WebdynSunPM – User guide — Version 1.0
7.2.2 Factory reset
The Reset button enables product recovery in all situations (such as loss of IP address, loss of IDs and
passwords, etc.).
Pressing the Reset button for a prolonged time causes the Activity light to flash regularly (at one-
second intervals).
- If the button is released within the first four seconds (four flashes), the concentrator
continues to operate normally.
- If the button is released after four seconds, and before 15 seconds (4-15 flashes), the
concentrator’s IP settings are reset.
- If the button is released after 15 seconds (15 flashes), the concentrator erases all its settings
and data and then restarts.
7.3 Embedded web interface
The integrated WebdynSunPM concentrator has an embedded web server allowing local
configuration of the product.
This embedded web server is accessible via the two network interfaces, as well as via the modem
connection, if it is configured.
You can access the web interface by entering its IP address directly into your web browser. The
default IP settings for Ethernet interfaces are as follows:
Interface
Parameters
LAN 1
IP address
192.168.1.12
Subnet mask
255.255.255.0
LAN 2
IP address
192.168.2.12
Subnet mask
255.255.255.0
The web interface of the WebdynSunPM concentrator is compatible with mainstream web browsers:
- Chrome (version 72.0 and higher);
- Firefox (version 65.0 and higher); and,
- Internet Explorer (version 11 and higher).
- Open your web browser and type the address: http://192.168.1.12