CFW-11 | 2-15
2.6 RECEIVING AND STORAGE
The CFW-11 inverters from the frame sizes F, G and H models are supplied packed in wooden boxes.
There is an identification label affixed to the outside of the package, identical to the one affixed to the side of
the inverter CFW-11.
To open the package:
1. Remove the package front cover.
2. Take out the polystyrene foam protection.
Verify whether:
1. The CFW-11 nameplate corresponds to the purchased model.
2. Any damage occurred during transportation.
If any problems are detected, contact the carrier immediately.
If the CFW-11 is not installed soon, store it in a clean and dry location (temperature between -25 °C and 60 °C
(-13 °F and 140 °F)), with a cover to prevent dust accumulation inside it.
ATTENTION!
When the inverter is stored for a long period, it becomes necessary to perform the capacitor reforming.
Refer to the procedure in the Section 6.5 PREVENTIVE MAINTENANCE on page 6-9 on Table 6.3
on page 6-9.
To Next Page
Loading...
