WEG CFW501 - Page 31

26 | CFW501
HMI (Keypad) and Basic Programming
English
NOTE!
When the inverter is in the fault state, the main display indicates the
number of the fault in the format Fxxxx. The browsing is allowed after the
activation of the key ESC, and the indication Fxxxx goes to the secondary
display until the fault is reset.
NOTE!
When the inverter is in the alarm state, the main display indicates the
number of the alarm in the format Axxxx. The browsing is allowed after
the activation of any key, and the indication Axxxx goes to the secondary
display until the situation causing the alarm is solved.
NOTE!
A list of parameters is presented in the quick reference of the parameters.
For further information about each parameter, refer to the programming
manual of the CFW501.