53
Polaris
ENGLISH
User manual
i
The system automatically exits the programming
phase about 10 seconds after the last operation
performed or press the STOP/PROG. button.
i
For programming, always use the right push-
button panel.
1,0 BAR 120°C P
09:16 09-10-12 5
DOSER ALARM
000 000 000 000
AUTOSTEAMER
65 °C
CUP HEATER
80°C
LANGUAGE
ENGLISH
CLEANING COUNTER
LIT.= NNNNN
REG. SOFTENER
00000
WORKING DAYS
1234567
AUTO ON/OFF
OFF 23:00
AUTO ON/OFF
ON 08:00
CLOCK SET-UP
09:16 18-10-12 1
(MODE ) x 5 sec.
(MODE
).
(MODE
).
(MODE
)
(MODE
)
(MODE
)
(MODE
)
(MODE
)
(MODE
)
(MODE
)
STOP
PROG.
Mode
( + )
Programming
Enter
( - )
13
Programming the machine’s
parameters
(only versions with DISPLAY)
13.1 Menu access
t To access the programming menu, press the
(MODE
) button and keep it pressed for at
least 5 seconds: until the led illumination
(MODE
), (ENTER ), (+ ), (- );
t use the (MODE
) key to scroll the various
areas of the programming menu;
t use the (ENTER
) button to move from one
parameter to another within the same area;
t to modify the value of each parameter, use the
increase (+
) and decrease (- ) button.
To Next Page
Loading...
