Wega Polaris 2GR User Manual

59
Polaris
ENGLISH
User manual
Regeneration notication
If the function has been enabled during the
programming, the system measures the amount of
water used by the machine and prompts the user
for regeneration (flashing of "WATER SOFTENER
REGENERATION") when the set amount has been
exceeded.
Once the regeneration has been carried out, the
counter must be reset.
15.2 Cappuccino maker
t Put the suction tube inside the milk;
t place the jug under the spout of the cappuccino
maker;
t open the steam tap, when the desired amount is
reached close the steam tap;
t pour the latte into the cups with the coee.
Z
Cleaning
Use special care in cleaning the cappuccino
maker, following the procedures indicated below:
t perform a rst washing by immerging the suction
tube in water and run a delivery for a few seconds;
t turn the rotating body (X) 90° to position B (clo-
sure of milk outlet duct);
t holding the milk suction tube in the air, dispense
steam (cappuccino maker dry run);
t wait about 20 seconds to allow for internal clean-
ing and sterilisation of the cappuccino maker;
t close the steam and put the rotating body back
in position A;
t if the air intake hole (Y) is blocked, clear it gently
with a pin.
X
Y
i
To carry out the resetting of the total of the liters,
see chap. 14.3.
i
To obtain the dispensing of warm milk without
foam, lift the tab (Z) upwards. For better results, we
suggest not to dispense directly into the coee cup,
but into a jug or pot, and to then pour the foamed
milk on the coee. Be sure the cappuccino maker is
kept clean as described in the chapter "Cleaning".
!
It is advisable to clean the cappuccino maker
after each period of continued use so as to avoid
malfunctions and to ensure a high rate of hygiene
in the system.
Pos.A Pos.B

Wega Polaris 2GR Specifications

General

Brand	Wega
Model	Polaris 2GR
Category	Coffee Maker
Language	English