WEIHONG NcEditor V12 - Page 101

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
99 / 144
Z-axis Manual Feed Jerk
Jerk in jog mode.
Used to control the jerk in jog mode.
Range: [16, 100000]mm/ s
3
Default value: 10000
W-axis Manual Feed Jerk
Jerk in jog mode.
Used to control the jerk in jog mode.
Range: [16, 100000]mm/ s
3
Default value: 10000
5.2.4 Machining Speed
G00 Speed
Default speed during positioning.
Range: [0.06, Maximum value of maximum speeds between XY-axes]mm/min
Default value: 30000
G00 Acc
Maximum acceleration of each axis during machining.
Range: [100, 100000]mm/ s
2
Default value: 10000
G00 Jerk
Change rate of single axis acceleration during rapid traverse.
Range: [0.001, 9999999]mm/ s
3
Default value: 100000