WEIHONG NcEditor V12 - Page 103

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
101 / 144
W-axis G00 Jerk
Change rate of single axis acceleration during rapid traverse.
Range: [0.001, 9999999]mm/ s
3
Default value: 100000
Pause Deceleration Time
Required time from running status to pause status or stop status.
Too short time may cause collision.
Range: [0.001, 10]s
Default value: 0.5
Frame Check S
Speed when cut frame.
Range: [0, Maximum value of maximum speeds among all axes]mm/min
Default value: 30000
X-axis Starting Speed
Range: [0, Maximum speed of X-axis]mm/min
Default value: 0
Y-axis Starting Speed
Range: [0, Maximum speed of Y-axis]mm/min
Default value: 0
Z-axis Starting Speed
Range: [0, Maximum speed of Z-axis]mm/min
Default value: 0
W-axis Starting Speed
Range: [0, Maximum speed of W-axis]mm/min
Default value: 0