WEIHONG NcEditor V12 - Page 109

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
107 / 144
5.3.5 Exchange Workbench
Enable Exchange Workbench
Whether to exchange workbench.
Default value: No
5.3.6 Focus Control
Enable Focus Control
Whether to enable focus control function.
Default value: No
5.3.7 Follow-up
Empty Move Collide Sensitivity
Used to control the sensitivity of touching workpiece signal during rapid traverse
process.
The greater the value is, the lower the sensitivity will be.
Range: [1, 10000]ms
Default value: 100
Cutting Collide Sensitivity
Used to control the sensitivity of touching workpiece signal during cutting.
The greater the value is, the lower the sensitivity will be.
During cutting a metal workpiece, the metal slag on the nozzle leads to an alarm of
touching workpiece. Set the value larger.
Range: [1, 10000]ms
Default value: 200
5.3.8 Laser Device
Laser Power
Voltage that corresponds to 100% laser power.
Range: [0, 10]V
Default value: 10