上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
89 / 144
Enable Soft Limit Protection
Used to prevent the machine tool from colliding with hard limit switch.
Yes: enable
No: not enable
Default value: Yes
Soft Limit Lower Limit
Lower limit of soft limit.
Range: [-999999, soft limit upper limit)mm
Default value: -3000
Soft Limit Upper Limit
Upper limit of soft limit.
Range: (soft limit lower limit, 999999]mm
Default value: 0
5.1.4 W-axis
Pulse Equivalent
Displacement or angle caused by per pulse in W-axis.
Range: [1E-08, 1000]mm/p
Default value: 0.001
Axis Direction
Moving direction of W-axis.
If the moving direction of W-axis is opposite to the direction judged by Right Hand
Rule when the machine tool is moved manually, modify the value of the this
parameter.
1: Positive
-1: Negative
Default value: 1
Max. Speed
Maximum allowable speed of W-axis.
Range: (0, maximum speed supported by hardware]mm/min
Default value: 36000
To Next Page
Loading...
