上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
90 / 144
Enable Soft Limit Protection
Used to prevent the machine tool from colliding with hard limit switch.
Yes: enable
No: not enable
Default value: Yes
Soft Limit Lower Limit
Lower limit of soft limit.
Range: [-999999, soft limit upper limit)mm
Default value: -3000
Soft Limit Upper Limit
Upper limit of soft limit.
Range: (soft limit lower limit, 999999]mm
Default value: 0
5.1.5 General Parameters
Force Homing before Machining
Whether returning to the machine origin is required before machining.
Used to retrieve machine coordinate system, so as to solve the problem that in case
of e-stop or power faiure during machining, deviation occurs after the incremental
machine tool is restarted.
Yes: force
No: not force
Default value: No
Limit Switch Used as Home Switch
Whether limit saitch can be used as home switch as well. That is, exclusive home
switch can be absent, and limit switch signal serves as home switch signal in
homing.
Yes: used
No: not used
Coarse Fine Positioning Minimum Distance
Minimum distance between coarse positioning and fine positioning signals.
Range: (0, 10]mm Default value: 2
To Next Page
Loading...
