Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-2 September 2014 Page 8
Data Recorder Board
If installed, the Data Recorder memory and Real Time Clock (RTC) components are located
on a plug-in daughter board attached to the front Display/CPU board.
CAUTION: Servicing of the Data Recorder/RTC circuit and replacement of
the lithium battery should only be carried out by a technically competent
technician.
Profiler Enabling
If you purchased a controller with the Profiler option installed, these features will be enabled
during manufacture.
Controllers supplied without the Profiler option installed can be upgraded in the field by
purchasing a licence code number from your supplier. A unique code must be purchased to
enable profiling on each controller that requires it.
Entering the Profiler Enable Code
Hold down the L and D keys during the power-up “splash screen”.
Using the D or U keys, enter the 16-character licence code in the displayed screen.
Press R to move on to the next character. Press L to move back to the previous
character.
Press R after entering the final character.
To confirm if profiling is installed in your instrument, check the Controller Feature Information
in Product & Service Information Mode.
To Next Page
Loading...