West Control Solutions Pro-EC44 - What Are the Sources for the Setpoints?; Is Input Re-Configuration Required?; Which Other Features Are to be Used?

Pro-EC44 2-Loop Graphical Profile Controller & Recorder
Pro-EC44 Product Manual - 59540-2 September 2014 Page 35
What are the sources for the setpoints?
 Local setpoint(s) only, or a remote setpoint input (see page 216 & 227).
 Profile Control (see page 87).
Is Input re-configuration required?
 Analogue input calibration & scaling (see page 70).
 Digital input functions (see page 75).
Which other features are to be used?
 Data Recorder (see page 97).
 Serial Communications (see page 109).
 USB Interface (see page 96).
Once you have an understanding of your application and how the controller will be used,
continue on to the configuration and use section below.
CAUTION: Configuration & commissioning must be completed before
proceeding to Operation Mode. It is the responsibility of the installing
engineer to ensure that the configuration is safe.