Wheatstone IP-12 - Page 42

page 4 – 5
IP-12/IP-16 / Dec 2014
WHEATNET-IP 88cb CONSOLE BLADE
The digital inputs of the WheatNet-IP 88cb (inputs 5‑8) will accommodate digital
inputs having a wide range of sample rates. These inputs will be sample rate converted to
the system’s chosen sample rate of 44.1kHz or 48kHz, which is set in the System Wizard
when bringing up the BLADE after a Factory Reset (or when rst setting the BLADE
up out of the box), or via the optional WheatNet‑IP
Navigator GUI. The GUI also allows
you to select input 8 of the digital BLADE, or of any BLADE that has a digital input as
input 8, to be a primary external reference, and a digital input 8 from a different BLADE
to be a secondary external reference. Please note that the sample rate of a digital input 8
should be the same, either 44.1kHz or 48kHz, as the system’s chosen sample rate.
AES sources are by design stereo; if the BLADE is not set to be stereo the appropriate
Left or Right signal within the AES stream will be applied to the signal path.
MIC IN XLR
XLR#1 Pin 1 – SH
XLR#1 Pin 2 – HI Mic 1 In
XLR#1 Pin 3 – LO
XLR#2 Pin 1 – SH
XLR#2 Pin 2 – HI Mic 2 In
XLR#2 Pin 3 – LO
Analog 1-4 RJ-45
RJ‑45#1 Pin 1 – HI
RJ‑45#1 Pin 2 – LO
RJ‑45#1 Pin 3 – HI
RJ‑45#1 Pin 6 – LO
RJ‑45#2 Pin 1 – HI
RJ‑45#2 Pin 2 – LO
RJ‑45#2 Pin 3 – HI
RJ‑45#2 Pin 6 – LO
RJ‑45#3 Pin 1 – HI
RJ‑45#3 Pin 2 – LO
RJ‑45#3 Pin 3 – HI
RJ‑45#3 Pin 6 – LO
RJ‑45#4 Pin 1 – HI
RJ‑45#4 Pin 2 – LO
RJ‑45#4 Pin 3 – HI
RJ‑45#4 Pin 6 – LO
Digital 5-8 RJ-45
RJ‑45#5 Pin 1 – HI
RJ‑45#5 Pin 2 – LO
RJ‑45#6 Pin 1 – HI
RJ‑45#6 Pin 2 – LO
RJ‑45#7 Pin 1 – HI
RJ‑45#7 Pin 2 – LO
RJ‑45#8 Pin 1 – HI
RJ‑45#8 Pin 2 – LO
Line 1 Lt In
Line 1 Rt In
Line 3 Lt In
Line 3 Rt In
AES 5 In
AES 6 In
Line 2 Lt In
Line 2 Rt In
Line 4 Lt In
Line 4 Rt In
AES 7 In
AES 8 In