Whirlpool WFW94HEX - Connect Drain Hose

2-5
INSTALLATION INSTRUCTIONS (continued)
Loosen bolts with a 13 mm (1/2") wrench. Slide each bolt and
spacer to center of hole. Pull bolts and plastic spacers from
back of washer. Discard bolts and spacers.
Loosen bolts witha13mm (1/2 )w
r
ench Slide each bolt and
Loosen bolts with a13mm(1/2
"
)w
r
ench Slide each bolt and
3. Remove transport bolts from
washer
Close bolt holes on cabinet back with four transport bolt hole
plugs included with washer parts.
Close bolt holes on cabinet back with four transport bolt hole
Cl blhl bi bkihfblhl
4. Cover bolt holes with transport
bolt hole plugs
Pull power cord through opening in rear panel and close hole
with attached cap.
NOTE: If washer is transported at later date, call your
local service center to avoid suspension and structural
washer for relocation.
Pllpoerco
r
dth
r
ogh opening in
r
ear panel and close hole
ll
dh
h
ldlhl
5. Remove power cord
CONNECT DRAIN HOSE
6. Place power cord over top
Remove the yellow shipping strap from the cord. Gently
place power cord over top of washer to allow free access
to back of washer.
If clamp is not already in place on elbow end of drain hose,
slide it over end of hose, centering it between the ribs, as
shown. Squeeze clamp with pliers and slide elbow end of
drain hose onto drain port and secure with clamp.
For a laundry tub or standpipe drain, go to step 9.
as shown in Step 8. Yo u may need additional parts with
separate directions. See “Alternative Parts”.
If litl
di llb
7.
Attach drain hose to drain port
bdfd ih
lb
p
Ribs
CONNECT DRAIN HOSE