4-9
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the top cover from the washer.
See
"REMOVING THE DISPENSER DRAWER, TOP
AND CONSOLE ASSEMBLY"
for the procedure).
REMOVING THE DETERGENT DISPENSER ASSEMBLY
4. Remove the console from the washer (see
step 5 "REMOVING THE DISPENSER DRAWER, TOP
AND CONSOLE ASSEMBLY" for the procedure).
8. Lift the locking tabs and remove the two
wire connectors from the detergent dis-
penser motor terminals.
9. Remove 1 screw from the center support
bracket.
Detergent Dispenser
5. Loosen the clamp and remove the water sup-
ply tube from the detergent dispenser.
Vent Tube
Water Supply Hose
Dispenser Motor
Terminal
Connectors
Support Bracket
Remove this Screw
7. Remove the detergent dispenser screws
from the front and top of the washer.
6. Loosen the clamp and remove the tub-to-
dispenser vent tube from the dispenser.
To Next Page
Loading...
