20. Plug into a grounded 3 prong outlet
COMPLE
TE IN
S
TA
LL
A
TION
CHECK LIS
T
�
Check electrical requirements. Be sure you have correct
electrical supply and recommended grounding method.
�
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
�
Check that you have all of your tools.
�
Check that transport materials were completely
removed from back of washer.
�
Check that both hot and cold hoses are attached and water
faucets are on.
�
Check for leaks around faucets, valves, and inlet hoses.
�
remaining on washer.
�
Check that washer is plugged into a grounded
3 prong outlet.
�
Dispose of/recycle all packaging materials.
�
Read “Using Your Washer” in your Washer Use and Care
Guide.
�
To test and clean your washer, press power and choose the
QUICK WASH cycle and run it without clothes. Use only HE
detergent. Use 1/2 the manufacturer’s recommended amount
for a medium-size load.
If washer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer cabinet. Then turn the
leveling foot clockwise to lower the washer or counterclockwise
to raise the washer. Recheck levelness of washer and that all
HELPFUL TIP: You may want to prop up front of washer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer.
to turn jam nuts counterclockwise on leveling feet tightly
against washer cabinet.
HELPFUL TIP: You may want to prop washer with
wooden block.
To Next Page
Loading...
