Whirlpool WFW94HEX - Manually Unlocking the Door Lock System

5-16
COMPONENT TESTING (continued)
FOR SERVICE TECHNICIAN’S USE ONLY
Manually Unlocking
the Door Lock System
1. Unplug washer or disconnect power.
2. Remove the top washer panel.
3.
Reach down along the inside of the front
(between tub and CCU) and locate the top
of the door switch/lock assembly.
4. Located on the top of the door switch/
lock assembly is a ring-shaped tab.
5. Gently pull the tab upward about ¼"
or unl a click is heard.
6. The door may be opened.
Component Removal
Components accessible through top panel:
Cycle Control Unit (CCU)
Pressure Sensor/Switch
Interference Filter
Water Valve Assembly
Flow Meter
Dispensing System
Dispenser Motor
User Interface/Console
Components accessible through back panel:
Drive Motor
Motor Control Unit (MCU)
Components accessible through front panel:
Door Lock/Switch Assembly
Drum Light
Drain Pump/Filter
Heater
Temperature Sensor