Whistler WS1040 User Manual

45
You can program a wildcard for any SAME code that
matches 48 for the state of Texas:
*48***
To activate SAME standby mode:
1. Press WX. The scanner quickly locates an active
weather radio frequency.
2. When the scanner stops on a frequency, press the
Stby softkey. The softkey will change to STBY,
and the scanner will alert when a matching SAME
message is received.
3. To exit SAME Standby Mode, press the Stby
softkey again, or press MAN, SCAN or PGM.
Your scanner will resume SAME Standby operation 90
seconds after the SAME warning starts. You may reset
standby mode by pressing the Stby softkey twice at
any time.
SAME STANDBY

Whistler WS1040 Specifications

General

Channels	1800
Display	LCD
Power Source	AA batteries or AC adapter
CTCSS/DCS	Yes
Trunking	Motorola, EDACS, LTR
Close Call RF Capture	Yes
Priority Scan	Yes
Weather Alert	YES
Type	Handheld
Digital Modes	P25 Phase I
Modulation Modes	AM, FM
PC Connectivity	Yes
Frequency Coverage	25-54 MHz, 108-174 MHz, 216-512 MHz, 764-960 MHz, 1240-1300 MHz