WIKA operating instructions, model CEP6000
MM/YYYY country code based on 10/2014 GB/CN
GB
Symbols
Before commissioning the instrument, ensure you read the operating
instructions!
Instruments bearing this mark comply with the relevant European direc-
tives.
This marking on the instruments indicates that they must not be disposed
of in domestic waste. The disposal is carried out by return to the manufac-
turer or by the corresponding municipal authorities (see EU directive
2002/96/EC).
4. Design and function
The model CEP6000 hand-held multi-function calibrator is a battery-operated hand-held
instrument which can measure and output/simulate current, voltage, resistance, RTD’s,
TC’s, frequency and pulses.
In addition, external pressure sensors/pressure modules can be connected which enable
pressure to measure with this calibrator. The WIKA model CPT6600 pressure modules
and the Mensor model CPT6100/CPT6180 precision pressure sensors are compatible
here.
4.1 Front foil
The following figures show the location of the input and output terminals and also the
positions of the buttons on the calibrator.
3. Safety / 4. Design and function
To Next Page
Loading...