WIKA CEP6000 - Troubleshooting Common Faults

38
WIKA operating instructions, model CEP6000
MM/YYYY country code based on 10/2014 GB/CN
GB
–
+
F1
HOME
7
F2 F3
89CE
E
N
T
E
R
4
1
MEASURE / SOURCE
3W
mA+
TC
V
mA
Loop
+
V
Hz
–
+
–
5
2
0
6
3
.
4W
mA–
MEASURE
–
CEP6000
Ω
Calibrating a pressure transmitter
Pressure module
and pressure
module adapter
pressure transmitter (see following figure).
4. Zero the pressure module (see chapter 6.2.10 “Menu function “ZERO””).
5. Test the pressure transmitter at (for example) 0 % and 100 % of the measuring range.
7. Faults
Personnel: Skilled personnel
CAUTION!
Physical injuries and damage to property and the environment
If faults cannot be eliminated by means of the listed measures, the model
CEP6000 hand-held multi-function calibrator must be shut down immedi-
ately.
▶
Ensure that pressure or signal is no longer present and protect against
accidental commissioning.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given in chapter 9.2
“Return”.
6. Commissioning, operation / 7. Faults